TSI Instruments Q-Trak XP - Units of Measure

Operation and Service Manual 29
4. Enter the network password
in the Network Password
field.
5. Select the CONNECT button
to connect the Q-Trak™ XP
monitor to the network.
6. Once connected the
Connection Status, IP
Address, Subnet Mask,
Connection Type, Default
Gateway, and MAC Address
will populate.
7. Select the Done button to
exit the Network Settings
page.
Units of Measure
The Units of Measure page is
used to set the units of measure
for the installed sensors.
1. Select icon to view
the list of available units
of measure.
2. Select the desire unit
of measure.
3. Select SAVE button to
save changes.