Revision C – January 2023
CDS2000 Page | 17
CDS2000Models
For best equipment performance, follow these installation/operation/programming instructions:
1. Ensure that you have removed all the equipment from the shipping box:
2. Install any piping that was ordered. The temperature probe coupling should be down-stream of
the turbine.
3. Mount the CDS2000 at a height and angle ensuring ease of accessibility and visibility.
a. Avoid installing under piping that defrosts often or near pumps that may spray liquid.
b. Use at least (Quantity 4) ¼”-20 bolts with lock washers and/or lock nuts.
4. Install cables and connect to the rear panel. Do not over tighten! Connectors should be
hand tight.
a. Route cables and tie wrap excess so that no rubbing of the cables will occur.
b. Allow slack in the cables to allow the CDS2000 to rotate for easy access to the rear
panel.
5. Connect the power cable to the vehicle battery or other constant power source. Please Note: It
is NOT recommended to connect the power to the lighting system of the truck/trailer.
a. Power connections are polarity insensitive (+ and – may be reversed).
6. Install the temperature probe:
a. If using the PCO control: downstream of the pump.
b. If not using the PCO: downstream of the turbine.
c. Connect the temperature probe wire to the top of the temperature probe. Tighten
cable lock nut hand tight.
7. Install turbine meter and connect to signal cable or connect signal cable to existing meter.
Tighten cable lock nut hand tight.
8. Press the CDS2000 power button and observe LED lights are on or flashing. The main LCD
screen will indicate operating mode.
Part#PartDescription LE LEPS LEPD LS LSO
CDS2000 TotalizerMainUnit *****
900037 PowerCable *****
900038 SignalCable *****
900039 Temp eratureCable * * *
900040 MountingBracket *****
900206 RTDInlin eTemperatureSensor * * *
901169 Knobs(2) *****
900039‐Dual DualTemperatureCable * *
901270 PumpHousingTempSensor * *
900062 PCOCable * * * *
901329 DifferentialPressureSensor * *
900063 Pressur eCable * * * *
900558 Pressur eSensor * *
900559 Pressur eSensorCable * *
900206‐O2L2 O2CleanedRTDTempSensor * *
CDS2000
CDS2000Model#
To Next Page
Loading...