turck TBEN-S2-4IOL - Mounting; Combine TBEN-S Modules for Mounting

Mounting
Combine TBEN-S modules for mounting
18
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | more@turck.com | www.turck.com
6 Mounting
The device can be mounted on a DIN rail according to EN 60715 (TS35) or screwed onto an
even mounting plate. Both composite and individual assembly are possible.
6.1 Combine TBEN-S modules for mounting
The modules can be mounted individually or in combination as a group of modules on a
mounting plate or DIN rail.
6.1.1 Combine TBEN-S modules for composite mounting to a mounting plate
The TBNN-S0-STD connector serves for composite mounting of TBEN-S modules on a mounting
plate:
 Unlock the cover flap at the connector with a flat tool (e.g. screw driver) (1).
 Open the flap completely (2).
 Connect the module and the connector so that the spring of the connector is inserted
into the groove of the TBEN-S module (3).
 Flap back the cover and close it (4). It has to engage audibly.
 Repeat steps 1 to 4 until the module group in complete.
1
2
3
Fig.5: Step 1 Fig.6: Step 2
4
Fig.7: Step 3 Fig.8: Step 4