turck TBEN-S2-4IOL - Attach TBEN-S Modules to a Mounting Plate; Mounting TBEN-S Modules on a DIN Rail (TS35)

Mounting
Mounting the device outdoors
20
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | more@turck.com | www.turck.com
6.2 Attach TBEN-S modules to a mounting plate
 Fasten the module or module composite to a mounting plate with two M4 screws per
device. The maximum tightening torque for the M4 screws is 1.3 Nm
 Avoid mechanical stresses.
 Optional: Ground the device.
Fig.13: Mounting the device on a mounting plate
6.3 Mounting TBEN-S modules on a DIN rail (TS35)
 For composite or single mounting: Mount connectors to the left and to the right of the
module.
 Place the module or module composite on the DIN rail so that the cut-outs in the con-
nector enclose the DIN rail (1).
 Avoid mechanical stresses.
 Close the rotating bolt of the connector with a screwdriver (2).
 Optional: Ground the device.
5
6
Fig.14: Mounting a module composite on a DIN rail
NOTE
To increase stability on the DIN rail, end brackets can be mounted on the right and
left of the module or the module combination.
6.4 Mounting the device outdoors
The device is UV-resistant according to DIN EN ISO 4892-2. Direct sunlight can cause material
abrasion and color changes. The mechanical and electrical properties of the device are not af-
fected.
 To avoid material abrasion and color changes: Protect the device from direct sunlight,
e.g. by using protective shields.