V01.00 | 2019/10
41
IOL-Error Type Designation acc. to IO-
Link Spec.
Meaning
0x1000 COM_ERR Communication error
Possible source: the addressed port is parameterized
as digital input DI and is not in IO-Link mode
0x1100 I_SERVICE_TIMEOUT Timeout in communication, device does not respond
in time
0x5600 M_ISDU_CHECKSUM Master reports checksum error, access to device not
possible
0x5700 M_ISDU_ILLEGAL Device can not respond to master request
0x8000 APP_DEV Application error in the device
0x8011 IDX_NOTAVAIL Index not available
0x8012 SUBIDX_NOTAVAIL Sub-Index not available
0x8020 SERV_NOTAVAIL The service is temporarily not available.
0x8021 SERV_NOTA-
VAIL_LOCCTRL
Service temporarily not available, device is busy (e. g.
teaching or parameterization of the device via the
master active)
0x8022 SERV_NOTAVAIL_DEVC-
TRL
Service temporarily not available, device is busy (e. g.
teaching or parameterization of the device via DTM/
PLC etc. active)
0x8023 IDX_NOT_WRITEABLE Access denied, Index cannot be written
0x8030 PAR_VALOUTOFRNG Parameter value out of the valid range
0x8031 PAR_VALGTLIM Parameter value above the upper limit
0x8032 PAR_VALLTLIM Parameter value value below the lower limit
0x8033 VAL_LENOVRRUN Length of data to be written does not match the
length defined for this parameter
0x8034 VAL_LENUNDRUN
0x8035 FUNC_NOTAVAIL Function not available in the device
0x8036 FUNC_UNAVAILTEMP Function temporarily unavailable in the device
0x8040 PARA_SETINVALID Invalid parameter: Parameters not consistent with
other parameters in the device.
0x8041 PARA_SETINCONSIST Inconsistent parameters
0x8082 APP_DEVNOTRDY Application not ready, device busy
0x8100 UNSPECIFIC Vendor specific, according to device documentation
0x8101…
0x8FF
VENDOR_SPECIFIC
To Next Page
Loading...
