Page 31 of 66 Pages
3. Start/ Stop key
This key commands the following 3 functions:
Starting the process.
Stopping the process.
Canceling the FAIL message from the command panel and
opening the electric door locking if available.
Note: “STOP” does not operate in EXH stage.
Starting the process:
It is active while the autoclave is in standby position, if the door
is closed and water level in the reservoir is normal, pressing this
key starts the selected process.
Stopping the process:
It is active while the autoclave is in process, pressing this key at
any stage of the process stops operation.
Canceling the FAIL message
The end of an aborted process, the FAIL light is turned on and
an error message is displayed on the screen indicating the cause
of the failure.
Pressing this key or opening the door cancels the displayed
message and switches off the FAIL light.
4. Program key
This key is designed for programming the clock and setting
different parameters by the service technician by means of the
UP (5) DOWN (6) keys.
When the PROGRAM key is pressed, the date is displayed with
the cursor under the day. Pressing the PROGRAM key again
moves the cursor under the month and then on to the year.
After pressing the PROGRAM key again the time of the day
will be displayed with the cursor under the hour. Pressing the
PROGRAM key again moves the cursor to the minutes
parameter. Each time the UP/DN key is pressed, the value of
the parameter above the cursor is changed.
After the date and time parameters are set, pressing the
PROGRAM key shows CODE: 000.
A code known to the technical personnel will be set to change
certain parameters and perform a digital calibration of the
system, as described in detail in the technician section.
To Next Page
Loading...
