Page 60 of 66 Pages
TROUBLESHOOTING
Only technical personnel having proper qualifications and holding technical documentation (including a technician
manual) and adequate information are authorized to service the apparatus beyond operations described below.
Solution
1.1 Check the outlet at the facility and verify that voltage requirements of the unit have been met,
including phase.
1.2 Make sure the main switch is in the ‘On’ position.
(see front view drawing).
1.3 Make sure the power cord is properly connected to the machine and the mains.
(see rear view drawing)
2.1 Make sure the machine has the proper amount of sterilization load (not over loaded)
31 Verify that there is water in the reservoir. Add if required.
3.2 Clean the water level electrode inside the vessel.
3.3 Check the leveling of the machine.(see para. 6, Installation).
4.1 Verify that no instruments are in contact with the water level electrodes.
4.2 Check the door for leakage and replace the door gasket if necessary.
(see para. 9.5 Replacing the Door Gasket)
Problem
1. The machine is not
responding
2. ‘Low Heat’ is displayed
3. ‘Low Water’ is displayed
4. ‘Low Pres’ is displayed
To Next Page
Loading...
