Page 36 of 66 Pages
Door Unlock Message is displayed and the DOOR CLOSED, LED
indicator flashes if the door is improperly closed. The
START button is pressed to start the desired cycle. If the
door accidentally opens during any stage of the cycle, the
same message and indicator appears, and the system reacts
as if the STOP key was pressed.
Electrode Message is displayed if the water level electrode is dirty.
In this case the message “clean electrode” will be printed
at the end of the cycle on the printer’s output.
No Liquids! Message is displayed, on the bottom row, after pressing
the START/ STOP key to start cycles 1 or 2 (Instruments).
This massage is intended to remind the operator not to
sterilize liquids with these two programs. The message
disappears after pressing again the START/ STOP key.
To Next Page
Loading...
