⑥ Charge lamp
This lamp will go off as soon as the engine starts to run to indicate that the
alternator is charging (Please note, as broken fan belt can cause the light to
come on, please stop the engine as overheating can occur if not rectified
immediately).
⑦ Glow signal Lamp
This lamp indicates pre-heating.
⑧ Turn Signal Lamp
These lamps are used to indicate operator’s turn direction.
When indicator is pulled down, left turn signal turns ON and flashes.
When indicator is pushed up, right turn signal turns ON and flashes.
These lamps will turn on and flash when hazard waning switch is pushed.
35
To Next Page
Loading...
