HYDRAULICS
The hydraulics are powered with an engine driven hydraulic pump and controlled with a position
control lever mounted beside the driver.
POSITION CONTROL
Implements can be raised and lowered with the hydraulic position control lever and can be stopped
at any position by stopping the lever.
To ensure a consistent working depth the adjustable stop can be set to ensure that the implement
returns to the same depth every time.
To raise the implement : Pull the lever back
To lower the implement : Push the lever forward
CAUTION
After finishing the work, always lower the implement to the ground and switch
off the engine, Set the parking brake to avoid injuries and accidents.
53
To Next Page
Loading...
Need help?
General
