ENGINE OIL
Engine Oil Cap
■ Checking Engine Oil
1. Park tractor on level surface
2 Check the engine oil when engine is cool enough
.
3. Pull out the dipstick, wipe it clean and dip in the oil sump.
4. Ensure that oil level is near the upper mark between the
upper and lower mark.
5. If too low, add oil through the oil filler cap, but never
excess 100 hours of service interval.
■ Changing Engine Oil
1. Park tractor on level surface, shut-off engine
2. Open the hood.
3. Remove the drain plug from the bottom of the
dipstick
oil pan and allow the oil to drain.
4. Replace and install the sump plug.
5. Fill the engine oil to the correct level on the
dipstick (approximately 1.14 US gal).
6. The grade of oil to be used will depend on the
ambient temperature.
ppe
rom
ac
ory :
Temperature over 77Ԭ : SAE 30
32Ԭ-77Ԭ : SAE20 or 10W/30
below 32Ԭ : SAE 10W
■ Changing Engine Oil Filter
1. Remove the oil filter using a filter wrench.
Smear lightly the rubber seal on the new filter with oil
Apply oil
.
to ensure.
3.Turn the filter clockwise until the seal contacts the
base and then turn it another 2/3 turn to tighten it
Installing New Oil Filter
When changing the oil always change the filter
64
IMPORTANT
.
Always use the same oil, as using different oils or specifications can cause
damage.
Dispose off the old oil as per local regulations.
To Next Page
Loading...
Need help?
General
