UES AG · Breuershofstr. 48 · 47807 Krefeld · Germany
Tel.: 0049-2151-72950 · Fax: 0049-2151-729578 · info@ues-ag.net · www.ues-ag.net
In this menu section, you can change all temperature settings. From sensor type to password
protection, settings can be made here.
*1 note: The set tank temperature (T1) refers to the tank. With the parameter
„Temperature difference“ you can set the required temperature for
manifold/pump by setting the temperature difference to Tank (T1).
→ for example: Tank = T1 150 °C, difference + 20 °C
→ means 170 °C set temperature for manifold/pump
*2 note: The purpose of this feature, especially for large tanks, is to compensate
the lowering of the temperature when new granulate is filled into the unit,
so that the Ready signal remains.
To Next Page
Loading...
