UES AG · Breuershofstr. 48 · 47807 Krefeld · Germany
Tel.: 0049-2151-72950 · Fax: 0049-2151-729578 · info@ues-ag.net · www.ues-ag.net
Basic cleaning
• Drain the old glue via the tank filter.
• Loosen coarse debris from the tank by using a wooden spatula. If the contaminants are very
strong, please contact UES AG for information on alternative cleaning options. Fill new glue into
the tank and set the temperatures for the material hoses down to about 90 °C so that the glue
becomes more viscous.
• Loosen the hoses from the heads and hang them in a collection container.
• Set a high pump pressure so that the viscous glue is pumped through the system and hardened
glue can mostly be rinsed out.
• If only clean adhesive flows out of the hoses, switch off the pump and attach the application heads.
• Screw off the nozzles and repeat step 6 (follow the safety instructions).
• Screw the nozzles back on.
• After the nozzles are heated, your system is ready for use again.
To Next Page
Loading...
