UES perfectMelt - Integration of Several Channel Boards

UES AG · Breuershofstr. 48 · 47807 Krefeld · Germany
Tel.: 0049-2151-72950 · Fax: 0049-2151-729578 · info@ues-ag.net · www.ues-ag.net
52
Integration of several channel boards
If more than one channel board is installed in your system, these must be addressed according to the
following table in the case of an exchange:
The dip-switches must be addressed differently depending on the number of boards, so that they are
recognized correctly by the main board. The fields marked with "X" do not have to be observed. In
addition, the boards must be connected to each other with a bus cable.
Attention!
If the entered address is wrong, duplicated or not in the correct
order the values are not displayed correctly or not at all.
Dip switch settings
SW1
SW2
SW3
SW4
Circuit board
Off
Off
x
x
1
On
Off
x
x
2
Off
On
x
x
3
On
On
x
x
4
Dip switch settings
SW1
SW2
SW3
SW4
Circuit board
Off
Off
x
x
1
On
Off
x
x
2
Off
On
x
x
3
On
On
x
x
4