UES AG · Breuershofstr. 48 · 47807 Krefeld · Germany
Tel.: 0049-2151-72950 · Fax: 0049-2151-729578 · info@ues-ag.net · www.ues-ag.net
Commissioning
Quick start
In order to be able to work with your perfectMelt, you only need a few steps to put it into operation. All the
parameters are pre-set so that you only have to adjust the values to your requirements. You have made
all the electrical and pneumatic connections and connected your peripherals.
Now, turn on the perfectMelt with the main switch. The system is now in the off-line mode. Touch the
screen in the middle of the switch symbol until the system jumps to the on-line mode.
You can also turn the system on via the rotary adjustment knob. Press it until the system switches to the
on-line mode. After a few seconds, the display jumps to the Overview display. Set the appropriate
temperature tank by tapping on the Tank Temperature field.
This opens the input window. Here, enter your value and confirm your entry with Enter. Then, set the
temperatures for each channel that you need. You either enter this area by using the "down arrow key" or
the Overview by touching the Channel temperatures field. Here, activate the hose and the application
head and set the corresponding temperatures. At the end, confirm your entries with ENTER. The system
starts to heat up the individual temperature ranges. Once the temperatures have been reached, the
READY signal will be activated. Now please set the appropriate working pressure on the pressure
regulator.
Your system is ready!
To Next Page
Loading...
