UES perfectMelt - Page 59

UES AG · Breuershofstr. 48 · 47807 Krefeld · Germany
Tel.: 0049-2151-72950 · Fax: 0049-2151-729578 · info@ues-ag.net · www.ues-ag.net
59
The following harmonised standards have been applied:
EN 55011:2009/A1:2010
Industrial, scientific and medical equipment – Radio
disturbance– Value limits and methods of measurement
(CISPR 11:2009/A1:2010)
EN 60204-1:2006/A1:2009
Machinery safety – Electrical equipment of machines – Part
1: General requirements (IEC 60204-1:2005/A1:2008)
EN 60204-1:2006/AC:2010
Machinery safety – Electrical equipment of machines – Part
1: General requirements (IEC 60204-1:2005 [modified])
EN 60204-1:2006
Machinery safety – Electrical equipment of machines – Part
1: General requirements (IEC 60204-1:2005 [modified])
EN 61000-6-2:2005/AC:2005
Electromagnetic compatibility (EMC) – Part 6-2: Generic
standards – Immunity for industrial environments (IEC
61000-6-2:2005)
EN 61000-6-2:2005
Electromagnetic compatibility (EMC) – Part 6-2: Generic
standards – Immunity for industrial environments (IEC
61000-6-2:2005)
EN 61000-6-4:2007/A1:2011
Electromagnetic compatibility (EMC) – Part 6-4: Generic
standards – Interference emission for industrial
environments (IEC 61000-6-4:2006/A1:2010)
EN 61000-6-4:2007
Electromagnetic compatibility (EMC) – Part 6-4: Generic
standards – Interference emission for industrial
environments (IEC 61000-6-4:2006)
EN 61310-2:2008
Machinery safety – Displays, labelling and service – Part 2:
Labelling requirements (IEC 61310-2:2007)
EN 809:1998+A1:2009/AC:2010
Pumps and pump units for liquids – Common safety
requirements
EN 809:1998+A1:2009
Pumps and pump units for liquids – Common safety
requirements
EN ISO 12100:2010
Safety of machinery – General principles for design – Risk
assessment and risk reduction (ISO 12100:2010)
EN ISO 13732-1:2008
Ergonomics of the thermal environment – Assessment
procedure for human responses in the case of contact with
surfaces – Part 1: Hot surfaces (ISO 13732-1:2006)
EN ISO 4413:2010
Fluid power technology – General rules and safety
requirements for hydraulic systems and their components
(ISO 4413:2010)
EN ISO 4414:2010
Fluid power technology – General rules and safety
requirements for pneumatic systems and their components
(ISO 4414:2010)