UHP NETWORKS SCPC - Figure 11 Transmit and Receive Configuration; Figure 12 Management of the Modulator; Modulator Settings; Receive and Transmit Configuration

UHP SCPC MODEM
USER MANUAL, v3.2
© ROMANTIS 2015 15 www.uhp.net
 Configuration of synchronization settings;
 Set up of automatic transmission level control (TLC);
 Activation of Station’s modulator.
2.3.2 Receive and Transmit Configuration
Transmit and Receive configuration should be entered into TDM/SCPC TX and TDM/SCPC RX forms respectively.
Once respective form is configured it should be applied to take effect.
Figure 11 Transmit and Receive Configuration
.
2.3.3 Modulator Settings
Activation of the Station’s modulator and adjustment of its initial power (transmitted carrier level) is performed in
“Modulator” section (see Figure 12).
Figure 12 Management of the modulator
Terminal-1
Terminal-2