III – Cleaning of the coffee and milk outlets
It is advised to disassemble daily the coffee and milk outlets for a carefully cleaning.
A) Coffee outlet
1. Put the coffee spouts down
2. Draw the spout to the front
3. Clean the spouts under a tap or directly in a dish-washer
4. Put again the spouts on the machine.
B) Milk outlet
1. Put the coffee spouts down
2. Draw the spout to the front
3. Disassemble the complete cappuccino device turning it to the right and drawing down.
4. Disassemble each part to proceed to an individual cleaning of these, silicone sucking tube
included.
5. Assemble again the whole.
IV – Cleaning of Steam outlet tube – Overflow tray - Body
A) Steam outlet tube
After each use, clean the steam tube with a wet rag and push steam push-button for a short
moment to eliminate the small amount of liquid (milk) left inside the tube.
Disassemble the end of the steam outlet to clean it more easily.
B) Overflow tray grid
Remove the overflow tray grid raising it forward.
With a sponge clean the overflow tray.
C) Body
Clean the body of the machine using a soft cloth and alcohol for the stainless-steel parts and
a non-abrasive detergent for the painted parts.
The blue "gates" can be removed to easy the access to the cleaning. For this purpose, it is
necessary to:
- Open the "gates"
- separate the small tongue of the axle
- remove down the "gates"
The waste drawer is completely in stainless steel, so it can be cleaned with water. You just
have not to scratch the painted parts.
V – Water softener
For the maintenance of your water softener, please refer to its instructions book.
D – 3
To Next Page
Loading...
Need help?
General
