TRANSFERT OF PROGRAMMATION DATA
WARNING USE ONLY THE DATA CARD SUPPLIED WITH THE MACHINE
DO NOT USE THE ANTERIOR DATA CARD
The use of the previous client and technician cards remain unchanged.
Operational way:
The machine must be put in position 1, no cycle working, without activated security.
c Insert the data card in the reader of machine
d Push on the touch PRO the display shows
e Dial the code corresponding to the operation you need according to the board hereunder
C O D E
4441 4442 4443 3331
OPERATION
To restore the data
F
ROM CARD TO MACHINE
To save the data
FROM MACHINE TO CARD
To restore Text
FROM CARD TO MACHINE
Reset
Coffee counters
DISPLAY
DOWNLOAD PARAMETERS
CONFIRM >>PRO
UPLOAD PARAMETERS
CONFIRM >>PRO
DOWNLOAD TEXT
CONFIRM >>PRO
COUNTERS RESET
CONFIRM >>PRO
ENTER TOUCH PRO TOUCH PRO TOUCH PRO TOUCH PRO
DISPLAY
DOWNLOAD PARAMETERS
WAIT
UPLOAD PARAMETERS
WAIT
DOWNLOAD TEXT
WAIT
Time Date
CODE > PRO
At the end of the transfer, the display goes back to initial state
Note:
- The code 4441 has for result to definitely replace the machine parameters by the card ones.
- The code 4442 has for result to definitely replace the card parameters by the machine ones.
- If some mistake occurs during the confirmation with PRO, stop with the main switch and do it again
after the switching on and the autocontrol phases.
E – 10
CODE
Code >
Time
Date
To Next Page
Loading...
Need help?
General
