1 / V108- SEPTEMBER 2002
STARTING WITH THE SERIAL NUMBER 0236XXX (SEPT 2002) ALL THE TANGO WILL BE EQUIPED WITH A
PROGRAMME V108 OR AN HIGHER ONE
I / PRESENTATION OF THE INNOVATION OF THE VERSION V108
1 – NEW CLEANING CYCLE
According to the request of the major part of our subsidiaries and after analysis of what is proposed by
competitors, we have modified the program in order to stop the machine after 26 hours if no cleaning
with tablets has been done. 20 hours after the last cleaning, a warning message appears on the display of
the machine to tell that a cleaning must be done in the next 6 hours. As soon as a cleaning has been done,
the countdown is thrown back for 26 hours.
x Tablet cleaning cycle compulsory every 26 hours.
x Total duration ӻ 8 minutes.
x Optimisation of each phase thanks to the separation of cleaning valve and discharge valve.
2 – NEW RINSING CYCLE
x Addition of a rinsing cycle each time the drawer capacity safety is reset by the key + 3sec.
3 – INTRODUCTION OF A NEW PROGRAMMING PARAMETER STI : START INFUSION
This new parameter is common to all the cycles “coffee”. It allows to control the start of the infusion and
then the pre-infusion mainly for the one cup cycles. The one cup quality is improved and more regular.
That means that the PS programming of the backward at – 04 is no longer needed and the programming
of all the parameters of “coffee” keys can be done only by the menu PP.
STI is programmable in the menu “Pro Packing Level” by pressing twice the + key to make appear STI =
00 and the PRO key to make “00” blinking then + or - for increasing or decreasing the value. .
STI = 00 is the factory setting (perfect adjustment in 95% of cases)
STI = > 00 delays the infusion
STI = < 00 anticipates the infusion
STI = >60 neutralises the effect of STI and goes back to a functioning similar to the previous version of
the V108.
E – 1
To Next Page
Loading...
Need help?
General
