Uniden BCD396T - Setting Tone-Out Standby; Setting up Tone-Out

111
Using Weather Alert (SAME)
You need tone-out setup information from the agency
you want to be alerted for or from online sources.
Uniden America Corporation does not have
information for local tone-out systems.
Setting Tone-Out Standby
   Tone-Out for ... 
Tone-Out Standby 
Turn the scroll control until the tone-out standby mode
you want to select appears. Then press the scroll
control to select it.
Setting up Tone-Out
   Tone-Out for ... 
Tone-Out Setup  
Tone-Out 1 - 10 select the tone-out you want to
work with.
• Edit Name - enter the name you want to assign
to the tone-out you selected.
• Set Frequency Lets you set the tone-out’s
frequency.
Edit Frequency Turn the scroll control to
enter the tone-out’s frequency.
Set Modulation:
• Auto - the scanner uses the default
modulation for the frequency band.
• FM - the scanner uses FM (frequency
modulation) for the frequency band.
• NFM - the scanner uses narrowband FM for
the frequency band.
Note: The default setting is Auto.
Set Attenuator Turn the scroll control to
select On or Off.
Menu
Menu