Uniden BCD396T - On-Air Cloning

58
Other Settings
On-Air Cloning
  Xfer Information  

On-Air Clone 
• Start Cloning Start on-air cloning.
• Set Frequency Lets you set the frequency
where your scanner receives the cloning
broadcast.
• Set Modulation Lets you set the cloning
broadcast’s modulation type.
To clone (copy) data from a transceiver to a BCD396T
scanner, you need a transceiver, a PC that has an
audio input, and a cable to connect your PC’s sound
card to the transceiver. Follow the directions supplied
with the Uniden Advanced Scanner Director Software
(available online at http://www.uniden.com) to
construct a cable and use on-air cloning.
When you are receiving the cloning broadcast and are
ready to clone the scanner, select Start Cloning
on the scanner. The scanner receives the data from
the transmission
When the transfer is complete, Complete appears. If
the transfer did not work, Error appears.
Menu