69
Programming Radio Systems
• See “Deleting Groups” on Page 83
• See “Editing the Channel Name” on Page 84
• See “Setting Group Lockout” on Page 83
Entering/Editing EDACS Channels
Refer to the appropriate section to change a
channel setting:
• See “Editing the Channel Name” on Page 84
• See “Setting Channel Lockout” on Page 89
• See “Deleting Channels” on Page 89
• See “Copying/Pasting Channels” on Page 90
To program another channel within the same group,
press , then repeat the above. To create another
channel group and enter more channels, press
three times, then proceed from “Entering/Editing
EDACS Channel Groups” on Page 68.
Programming LTR Systems
Program System
New System
LT
Confirm? Yes=”E” / No=”.”
The scanner creates an empty LTR system, with a
default name of System n L.
n is a number that increments as you add new
systems. L indicates that this is an LTR system.
Next, refer to the appropriate section to set system-
wide options. For most settings, you can accept the
default. However, for the items in bold, you must enter
information in order for your scanner to scan the
system.
• See “Editing the System Name” on Page 72
• See “Setting the System Hold Time” on Page 74
• See “Editing the System Quick Key” on Page 73
Menu
Menu
Menu
To Next Page
Loading...
Need help?
General