74
Programming/Editing Optional Settings
Note: You can also lock or unlock a system by press-
ing , selecting the system, then pressing +
L/O.
Setting the System Hold Time
Program System
Select the system
Edit Sys Option
Set Hold Time
This setting controls how many seconds the scanner
scans a system before moving to the next unlocked
system. Enter a value from 0-255, then press E to
save the setting.
Notes:
• If you select 0, the scanner stays on the system
for a minimal time (only long enough to check cur-
rent system activity).
• The default setting is 2 seconds for each system.
• For conventional systems, all unlocked channels
will be scanned at least once regardless of this
setting.
• The scanner moves to the next system after the
hold time expires, any current transmission ends,
and the channel delay time expires.
Setting the Channel Delay Time
Program System
Select the system
Edit Sys Option
Set Delay Time
This setting controls how many seconds the scanner
waits after a transmission ends before resuming
scanning. Enter a value from 1-5 or Off, then press
the scroll control.
Func Func
Menu
Menu
To Next Page
Loading...
Need help?
General