57
Other Settings
Wired Cloning
Xfer Information
Wired Clone
• Master Sets the scanner to be the source
scanner.
• Slave Sets the scanner to be the recipient
scanner.
To clone (copy) data directly from one BCD396T
scanner to another BCD396T scanner, you must first
connect the scanners to each other using the included
connection cables and a DB9 null modem adapter and
DB9 gender changer (neither included), available at
most computer stores. Then you must set one scanner
as the source and the other as the destination.
Plug the smaller end of each of the included connection
cables into Remote on the right side of each scanner.
Then connect the other end of the cables together
using the null modem connector and gender changer.
Then set the scanner containing the programming you
want to transfer as the master scanner, then set the
other scanner as the slave scanner.
(Master scanner) Clone Master Press SCAN Key
(Master scanner) Clone Slave Press SCAN Key
When you are ready to clone the scanner, press
on the slave scanner first, then on the master scanner.
The master scanner checks the connection between
the two scanners, then transfers its data to the slave
scanner.
When the transfer is complete, Complete appears on
both scanners. If the transfer did not work, Error
appears on the master scanner.
Menu
Scan
Scan
Scan
To Next Page
Loading...
Need help?
General