Uniden BCD396T - Priority Scan

54
Other Settings
Turning Power Save On or Off
  Settings  

Set Battery Save  
• On The scanner goes into low-power mode when
you monitor a conventional channel that has no
activity.
• Off Power save is off.
Priority Scan
  Set Priority  
Or, while holding on any channel, press + 1/Pri
to select one of these priority modes:
• Off Normal scanning
• On While scanning a conventional system, the
scanner interrupts every 2 seconds and checks
the priority channels in each unlocked
conventional system. Priority channels in lower
priority key numbered systems (starting from 1)
have highest priority. Pri appears when you
select this mode.
• Plus On The scanner only scans priority
channels in unlocked conventional systems.
Pri flashes when you select this mode.
Other Settings
Using the Backlight
  Settings  

Set Backlight  
• 10 sec The backlight stays on for 10 seconds
after you press .
• 30 sec The backlight stays on for 30 seconds
after you press .
• Squelch The backlight turns on when the
squelch opens then stays on for 5 seconds.
Menu
Menu
Func
Menu