33
Setting Up Your Scanner
Before installing batteries, set the switch in the battery
compartment to match the type of batteries you will
use. Select REG. ALK. BATT. for non-rechargeable
battery types and NI-MH. BATT. for rechargeable
battery types. See also “Using Rechargeable Batter-
ies” on Page 34 when you use rechargeable batteries.
1. Remove the battery cover and set the battery
switch.
2. Install 3 AA batteries, matching the polarity sym-
bols (+ -).
WARNING!
Set REG. ALK. BATT./NI-MH. BATT. to NI-MH.
BATT. for use only with rechargeable batteries.
Never attempt to recharge non-rechargeable
batteries. Non-rechargeable batteries can get hot
and can even burst if you try to recharge them.
(illus - show battery compartment
open and stylus pointing to
battery switch)
(illus - show batteries being
installed in batt compartment)
To Next Page
Loading...
