49
Operation
To toggle between ID Scan and ID Search, press F then press [SCAN/SEARCH]
while the scanner is scanning the system.
If the scanner does not scan the system long enough for you to easily do this,
press
F and rotate the Scroll Control to select the changed system. Then, press
[SCAN/SEARCH] within 2 seconds.
Holding On a System
To temporarily hold on a system, tap F. To hold on a different system, tap F then
rotate the control to select the system. Normal scanning resumes 2 seconds after
your last selection.
To permanently hold on a site or system, press and hold the Scroll Control for 2
seconds.
f flashes in the display’s upper left corner. The scanner continues to
scan only the current system. To hold on a different site or system, rotate the
Scroll Control
to select the new site or system then press [EYES].
Holding On a Channel
To hold on a channel, press [HOLD/RESUME] while the channel is active. To
select a different channel, turn the Scroll Control. If you scroll past the beginning
or end of the current system, the scanner selects channels in the previous or next
system. To resume scanning, press [SCAN/SEARCH].
Quickly Storing an ID During ID Search
To quickly store an active talk group ID during ID search, press [EYES]. You see:
Quick TGID Save?
To save the ID into a channel, press [EYES]. Otherwise, press [.No]. If you press
[E
YES], the scanner stores the ID into a channel group called Qck Save Grp in
the current system.
Quick-Storing Channels or Talk Group ID’s (TGID)
1. Hold on an existing channel in any system.
2. Enter the frequency or talk group ID you want to store (press [.No] twice to
enter hyphens in talk group ID’s).
3. To quick-store the channel or talk group ID, press [EYES].
Otherwise, press [.No].
To Next Page
Loading...
Need help?
General
