83
Programming Your Scanner
manually set the digital decode threshold. This setting affects all channels in the
current site. See
“Optimizing P25 Performance” on Page 52.
Auto — the scanner automatically adjusts the digital decode threshold to match
the transmission you are hearing when it receives a strong signal and has a high
decode rate.
Manual — lets you manually adjust the digital decode threshold. To manually
adjust the P25 level, select Manual.
Default — sets the digital decode threshold to the default value. Use this setting
to return to the value that usually provides adequate performance. This is handy is
you have manually adjusted the value to a setting that prevents proper decoding.
Note: This setting has no effect on how these sites are received.
[MENU] Program System F
Select a trunked system F
Edit Site F
Select a site F
Delete Site F
Confirm Delete?
Yes=”E” / No= ”.”
Important: Deleted sites cannot be restored. You must re-enter them.
[MENU] Program System F
Select a system F
Edit Group F
New Group F
The scanner creates a group with a default name of Group n. n increments by
one for each new group you create within a system.
[MENU] Program System F
Select a system F
Edit Group F
Deleting Sites ME
Programming Channel Groups MECL
Setting Up a Channel Group MECL
Editing a Channel Group Name MECL
To Next Page
Loading...
Need help?
General
