58
This setting controls the format used for displaying the time on the GPS data
screens.
12H — the scanner displays time in 12-hour format using am for mornings and pm
for evening times.
24H — the scanner displays time in 24-hour format using 0 for midnight and 23 for
11 pm.
Setting the Time Zone
[MENU] Settings F
Set GPS Format F
Set Time Zone F
This setting controls the format used for adjusting Universal time to local time. Set
your local time’s
offset from UTC (formally known as GMT).
Setting the Distance Units
[MENU] Settings F
Set GPS Format F
Set Unit F
This setting controls the distance units shown in the GPS data screens and used
for entering distance for POI’s
mile — The scanner uses miles.
km — The scanner uses kilometers.
Setting the Serial Port Speed
[MENU] Settings F
Set Serial Port F
Set Baud Rate F
Set Front Port or Set Rear Port F
Use this setting to control the data rate used for the front and back panel serial
ports. You typically set the front port to match the speed used to communicate with
your PC (default 115200 bps) and the back port to the speed used to communicate
with an attached GPS (default 4800 bps). Note that the back port is male. You may
need a gender changer and a null modem adapter to use a typical DB9 serial
cable from the rear port.
To Next Page
Loading...
Need help?
General
