Uniden BCD996T - Quick CTCSS;DCS Save; Setting Channel Modulation Method

88
 Edit Group F
 Select the channel group F
 Edit Channel F
 Select the channel F
 Set Audio Type F
 Analog Only F
At this point you can scroll to CTCSS or DCS and select the subaudible frequency
in the CTCSS range or the DCS code.
 CTCSS or DCS F
This setting controls how a sub audible CTCSS or DCS is used for the channel.
Select your setting, then press
F.
Off — any signal opens squelch. The default setting is Off.
Search — the scanner searches for and displays any CTCSS or DCS tone that
accompanies the transmission.
CTCSS — the scanner only opens squelch if the CTCSS tone you select is also
present with the signal. The scanner then prompts you to enter or scroll to the
desired tone.
DCS — the scanner only opens squelch if the DCS tone you select is also present
with the signal. The scanner then prompts you to enter or scroll to the desired
tone.
Set Lockout — the scanner does not stop on the channel if the tone you select
is present. The scanner prompts you to select a CTCSS or DCS tone.
Note: The scanner does not detect or decode a P25 digital signal if the channel or
search has CTCSS/DCS search turned on.
Quick CTCSS/DCS Save
If you set a channel to CTCSS/DCS Search and the scanner detects a tone, when
you press [E
YES], the first option is Save found CTCSS/DCS?
[MENU]  Program System F
 Select the conventional system F
 Edit Group F
 Select a channel group F
 Edit Channel F
Setting Channel Modulation Method C