VIRDI 4000
TM
User’s Manual
23
UNION COMMUNITY Co., Ltd. 44-3 Hyundai Topics Building, Bangi-dong,
Songpa-gu, Seoul, Korea 138-050, Tel: 82-2-6488-3000, Fax: 82-2-6488-3099,
E-Mail:sales@unioncomm.co.kr, http://www.unioncomm.co.kr/eng
<Enable 1:N >
( N=0/Y=1 ) : 1
The default is ‘0’. To enable 1:N authentication,
it should be set to ‘1’.
When there are not many users, or for the convenience of a specific user, a
fingerprint only without ID can be used for authentication. For authentication
without ID, it shall be set to ‘1’. For authentication with ID, it should be set to ‘0’.
Press [ENTER] to enter fingerprints.
<Add FP>
Input Your FP
A “ppiriririck” buzzer sound rings twice and a light on the fingerprint sensor turns
on. Place a finger onto the fingerprint input window and wait for 2~3 seconds
until the light turns off and the fingerprint is saved.
Please note that the same fingerprint must be input twice. To enter the same
fingerprint again, remove the finger from the window and place the same finger
again onto the window.
If registration succeeds, a “ppiririck” buzzer sound rings. Then, it returns to the
“1.Add” screen. If the fingerprint image is not in good condition or there is no
input in the window for 10 seconds after the fingerprint sensor light turns on, it
returns to the “1. Add” screen with a failure buzzer sound “ppibig”.
If the fingerprint to be registered is in bad condition, try to repeat the registration
process 2 or 3 times or register another fingerprint. For the remarkably few
people having fingerprints in bad condition, which are not properly accepted for
the registration process, it is recommended to use a password for authentication.
3.3.1.2. “2. ID&PW” registration
Password registration and password authentication for a user.
◆ [*] [1] [1] User ID [ENTER] [2]
Input PW [ENTER] Input same PW [ENTER] ◆
To Next Page
Loading...
Need help?
General
