Unitech MS837 - Chapter 4 GS1 Databar; GS1 Databar Limited

Chapter 4
GS1 Databar
Unitech’s MS837 scanner can be configured to scan GS1 Databar type bar codes.
Double Border Required - Due to the large spaces commonly found in
GS1 Databar symbologies, Unitech recommends double border
requirements be enabled when scanning GS1 Databar code type
symbologies.
Enable GS1 Databar 14
*
Disable GS1 Databar 14
*
Transmit GS1 Databar 14 Check Digit
Do Not Transmit GS1 Databar 14 Check Digit
*
Transmit GS1 Databar 14 Application ID - Application Identifier “01” is
transmitted by default.
Do Not Transmit GS1 Databar 14 Application ID
* Transmit GS1 Databar 14 Symbology ID - Symbology Identifier “]e0”
is transmitted by default.
Do Not Transmit GS1 Databar 14 Symbology
GS1 Databar Limited
Enable GS1 Databar Limited
*
Disable GS1 Databar Limited
*
Transmit GS1 Databar Limited CD
Do Not Transmit GS1 Databar Limited CD
17
Copyright 2012 unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of unitech Electronics Co., Ltd.