Chapter 9
Keyboard
Enable Keyboard Emulation
Load Keyboard Wedge Defaults - Loads the default settings for
keyboard wedge mode.
Enable Stand-Alone Keyboard Emulation - Use this with special
stand-alone models that are not cabled for an external keyboard. Scan
this bar code to enable the Stand-Alone Mode. The scanner will send
keyboard “power on” information and configure hardware to simulate a
constant keyboard connection.
Enable Keyboard Wedge Emulation - Use this with an external
keyboard. Transmit in wedge made to allow standard PC keyboards to
communicate when no bar code data is available.
Country/Scan Code Table Selects
*
USA Keyboard
Switzerland Keyboard
Spain Keyboard
Italy Keyboard
Germany Keyboard
France Keyboard
UK Keyboard
Belgium Keyboard
Japan Keyboard
37
Copyright 2012 unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of unitech Electronics Co., Ltd.
To Next Page
Loading...
