Unitech MS837 - Chapter 6: Scanner Operation; Trigger;Continuous Scan Modes; Beeper Options

Trigger/Continuous Scan Modes
Note:
To program the scanner to operate in
Continuous Scan Mode, first scan the
Enable Automatic Scanning bar
code, then scan the Continuous
Automatic Scanning bar code.
Enable Automatic Scanning
Continuous Automatic Scanning –
The laser blinks continuously and
the IR is inactive.
Enable Manual Trigger (Default
scanning mode) – The laser
activates when the CodeGate
button is pressed.
To restore the MS837 to its default
manual scanning mode, scan the
Enable Manual Trigger bar code.
Beeper Options
* Normal Tone
Optional Tone 1
Optional Tone 2
Optional Tone 3
Optional Tone 4
Optional Tone 5
Optional Tone 6
No Beep
* Beep Once on Supplements
Beep Twice on Supplements
Enable Fast Beep
* Disable Fast Beep
Enable Fun Tones – scan this bar
code then
scan one of the Optional Tone bar
codes above.
* Disable Fun Tones
24
Copyright 2012 unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of unitech Electronics Co., Ltd.