Unitech MS837 - GS1 Databar Expanded

* Transmit GS1 Databar Limited Application ID - Application identifier
“01” is transmitted by default.
Do Not Transmit GS1 Databar Limited Application ID
* Transmit GS1 Databar Limited Symbology ID - Symbology identifier
“]e0” is transmitted by default.
Do Not Transmit GS1 Databar Limited Symbology ID
GS1 Databar Expanded
Enable GS1 Databar Expanded
*
Disable GS1 Databar Expanded
* Transmit GS1 Databar Expanded Symbol ID - Symbology identifier
“]e0” is transmitted by default.
Do Not Transmit GS1 Databar Expanded Symbol ID
18
Copyright 2012 unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of unitech Electronics Co., Ltd.