Donation Identification Number + Donor Identification Number =á +
&; Concatenation
Donation Identification Number + Confidential Unit Exclusion
Status =á + &! Concatenation
Product Code + Expiration Date (Form 1) =< + =>Concatenation
Product Code + Expiration Date (Form 2) =< + &> Concatenation
Product Code + Expiration Date (Form 3) &< + => Concatenation
Product Code + Expiration Date (Form 4) &< + &> Concatenation
User-Defined Concatenation Configuration Mode
The first two bar codes shown below can be used to enable or disable user- defined
concatenation sequences. The remaining bar codes are used to enter the user-defined
identifiers used in the concatenation sequence. First enter configuration mode then scan the
one of the identifier codes, followed by the code byte sequence or the desired identifiers.
Enable User-Defined Sequences
Disable User-Defined Sequences
1
st
Left Identifier
2
nd
Left Identifier
1
st
Right Identifier
2
nd
Right Identifier
† This feature is only supported in the MS837 product series.
21
Copyright 2012 unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of unitech Electronics Co., Ltd.
To Next Page
Loading...
Need help?
General
