Unitech MS837 - Configuration Mode Options; Scan Buffers

Chapter 6
Scanner Operation
Configuration Mode Options
Allow Configuration Mode on Power Up.
* Allow Configuration Mode Anytime.
Allow configuration Codes on Power Up - Once a product bar code
is scanned after power- up, the scanner will not accept configuration
bar codes.
* Allow Configuration Codes Anytime - Allows scanning of
configuration bar codes at any time.
Scan Buffers
* 1 Scan Buffer - The scanner will scan one bar code in the scan field
and not scan again until the bar code is removed from the scan field for
the duration of the same symbol time out.
2 Scan Buffers - The scanner will scan two bar codes in the scan field
one time each. These two bar codes will not be scanned again and until
they are removed from the scan field for the duration of the same
symbol time out.
3 Scan Buffers - Same function as 2 Scan Buffers, but three bar codes
are in the scan field.
4 Scan Buffers - Same function as 2 Scan Buffers, but four bar codes
are in the scan field.
23
Copyright 2012 unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of unitech Electronics Co., Ltd.