Unitech MS837 - UPC Prefix ID Settings; NCR Prefix ID Settings; Nixdorf ID Character Settings; SANYO ID Character Settings

*
Disable UPC Prefix ID.
Enable NCR Prefix ID - A prefix will be transmitted before the following
code types. The prefixes are as follows: A (UPC-A), E0 (UPC-E), FF
(EAN-8), F (EAN 13), B1 (Code 39) B2 (ITF), B3 (Code 128 and other
codes).
*
Disable NCR Prefix ID
Enable NCR Prefix Character
Enable Nixdorf ID Characters - This option transmits code identities
before each bar code for many Siemen/Nixdorf registers.
*
Disable Nixdorf ID Characters
Enable SANYO ID Characters
*
Disable SANYO ID Characters
Enable Manufacturer ID Prefix
*
Disable Manufacturer ID Prefix
Enable “C” Prefix
*
Disable “C” Prefix
Enable “$” Prefix ID for UPC/EAN
*
Disable “$” Prefix ID for UPC/EAN
Enable Tab Prefix - The scanner will transmit a TAB (ASCII 09H)
before each bar code.
*
Disable Tab Prefix
Enable SNI Beetle Mode
*
Disable SNI Beetle Mode
28
Copyright 2012 unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of unitech Electronics Co., Ltd.