Unitronics Vision 260 - Table of Figures

41
Table of Figures
Figure 1. The Vision System........................................................................... 5
Figure 2. Vision Connectors and Mounting Brackets ..................................... 9
Figure 3. V230 Panel Cut-out—Front View ................................................. 12
Figure 4. V260/V280 Panel Cut-out—Front View ....................................... 13
Figure 5. Earth Assembly.............................................................................. 13
Figure 6. Panel Mounted—Rear View .......................................................... 14
Figure 7. Power Supply Wiring..................................................................... 16
Figure 8. Installing a Snap-in I/O Module..................................................... 18
Figure 9. Connecting the PC to the Controller.............................................. 20
Figure 10. CANbus Wiring Diagram .............................................................. 21
Figure 11. CANbus Connector........................................................................ 22
Figure 12. Navigating Information Mode ....................................................... 24
Figure 13. Information Mode: Hardware Configuration................................. 28
Figure 14. V230 Dimensions........................................................................... 37
Figure 15. V260/V280 Dimensions................................................................. 38
Figure 16. PLC Scan........................................................................................ 40