Chapter 2: Mounting
11
Mounting
Before you begin, note that the mounting panel cannot be more than 5 mm thick.
To maximize system performance, avoid electromagnetic interference by mounting the
controller on a metal panel and earthing the power supply according to the details in
Figure 7, page 16.
1. Make a panel cut-out that is appropriate for your model controller.
V230 cut-out dimensions are shown in Figure 3, page 12.
V260/V280 cut-out dimensions are shown in Figure 4, page 13.
2. If you are mounting the controller on a metal panel, earth the power supply:
a. Bore a hole, as shown below, that suits the NC6-32 screw supplied with the
controller kit.
b. Scrape the panel paint away from the contact area to ensure a conductive connection.
c. Drive the screw into the hole.
d. On the screw’s shank, place the following hardware in this order: washer, ring cable
shoe, second washer, spring, and nut; as shown in Figure 5, page 13.
3. Slide the controller into the cut-out, ensuring that the rubber seal is in place.
4. Push the 4 mounting brackets into their slots on the sides of the controller as shown in
Figure 2, page 9.
5. Tighten the bracket screws against the panel.
To Next Page
Loading...
Need help?
General
