Universal Robots ur3 Service Manual

9. Press YES to update the software.
10. Wait for update too complete, after successful update controller will automatically reboot.
11. Remove USB-stick and initialize the robot.
6.2. Update joint firmware
NOTICE
Read the complete section prior to updating your firmware.
Controller power MUST NOT be turned off during firmware update process.
Universal Robots assume no responsibility for any failed update caused by
improper operation.
Software version 3.1.16828 and newer:
When the software is updated on a robot the firmware is automatically updated.
After replacement of a joint on a robot the firmware is automatically updated.
Software version before 3.1.16828:
Instructions for updating firmware:
Prior to updating firmware, robot software must be updated.
Please refer to chapter Update software. When updating robot software, the firmware will
automatically be copied to a folder on the controller.
Service Manual 81 UR3
6.Software
Copyright © 2009–2021 by UniversalRobotsA/S. All rights reserved.

Universal Robots ur3 Specifications

General

Brand	Universal Robots
Model	ur3
Category	Robotics
Language	English