Universal Robots UR5 Service Manual

C298A Hand protection
C298A0 Tool is too close to
the lower arm
The tool is too close to the
lower Robot arm
a) Check wrist position.
b) Verify mounting
c) Do a Complete rebooting
sequence
d) Update software
e) Contact your local
Universal Robots service
provider for assistance
C299A Tool communication
C299A0 Communication
error detected
A problem with the Tool
communication was
detected.
a) Do a Complete rebooting
sequence
b) Update software
c) Contact your local
Universal Robots service
provider for assistance.
C299A1 Tool communication TX buffer overflow
C299A2 Tool communication New message started
unexpectedly
C299A3 RX framing error Framing error detected on
received data
a) Check external equipment
connection
b) Verify the communication
configuration matches the
hardware.
c) Do a Complete rebooting
sequence
d) Update software
e) Contact your local
Universal Robots service
provider for assistance
C299A4 RX Parity error Parity error detected on
received data
a) Check external equipment
connection
b) Verify the communication
configuration matches the
hardware.
c) Do a Complete rebooting
sequence
d) Update software
e) Contact your local
Universal Robots service
provider for assistance
C299A5 Tool communication RX buffer overflow.
C300A1 Safety message Safety message received
from an unexpected node.
UR5 178 Service Manual
7.Troubleshooting
Copyright © 2009–2021 by UniversalRobotsA/S. All rights reserved.

Universal Robots UR5 Specifications

General

Brand	Universal Robots
Model	UR5
Category	Robotics
Language	English