USR IOT USR-M100 - Factory Default Settings; Quick Test; Download the Software

User Manual
Your Trustworthy Industrial IoT Partner www.pusr.com
12
Table 5 LED indicators
LED name
status
description
POW
Steady on
Power supply is normal
Off
No power supply or abnormal power supply
WORK
Blinking
Power is on and the device is ready. System is booted up
and running
NET
Blinking
Ethernet WAN connection
Steady on
4G LTE network connection
off
No network
DATA
Blinking
Serial port is transmitting data
DO1
Steady on
Light on, the channel output is activated
DO2
Steady on
Light on, the channel output is activated
DI1
Steady on
Light on, the channel is activated by input signal
DI2
Steady on
Light on, the channel is activated by input signal
2.7. Factory default settings
The USR-M100 remote IO module comes with the following default settings.
Table 6
Default parameters
Parameter
Default Values
User Name
admin
Password
admin
Device IP address
192.168.0.7
Subnet Mask
255.255.255.0
Gateway IP
192.168.0.1
COM port
115200,None,8,1
COM operation mode
TCP server,23
MQTT
Disable
Edge computing
Disable
2.8. Quick test
USR-M100 has a built-in Web server, which provides a convenient way to access and configure the remote IO module. Users can use
Edge , Firefox or Google browser to access it. This chapter is a quick introduction to the USR-M100 smart IO gateway. It is
recommended that users read this chapter and follow the instructions once for the system, and you will have a basic understanding
of the product. For specific function details and instructions, please refer to the subsequent chapters.
2.8.1. Download the software
Download the setting software from PUSR’s website:
https://www.pusr.com/support/downloads/H7-version-set-up-software.html
https://www.pusr.com/support/downloads/usr-tcp232-test-V13.html
You may find it in the download section under your product page. Run the software when the installation has been completed as
shown in Fig.8 and Fig.9.