User Manual
Your Trustworthy Industrial IoT Partner www.pusr.com
the firmware, make sure that your host’s Network domain is as same as the gateway.
Next, click “Select the file” button as shown in Figure to find and choose the new firmware file. Then, click "Flashing the firmware"
button to start the firmware upgrade process. After the progress bar in the page is read, the software upgrade is completed. Please
wait until the uploading process is finished (the amount of time varies depending on the equipment used).
Finally, the device will then proceed to restart itself. In most cases, you might require to re-configure your device.
3.2. Configuration software
3.2.1. Discovering your gateway
After you start configuration software, if the USR-M100 gateway is already connected to the same gateway as your PC, the device can
be accessed via broadcast packets. Users can search all the USR-M100 gateways on the network and show them on the Deivce List
Area of the utility. Please select the right Ethernet adapter(Device menu) if you did not see any gateway.
Fig. 32 Searching
3.2.2. Network setting
Sometime the USR-M100 gateway might not be in the same subnet as your PC, therefore, you will have to use this utility to locate it in
your environment. To configure each device, first click to select the desired device (default IP:192.168.0.7) in the list of configuration
utility, and then change the IP address to avoid any IP address conflict with other hosts on your LAN, save your change.
To Next Page
Loading...