User Manual
Your Trustworthy Industrial IoT Partner www.pusr.com
change the IP type to DHCH, save your change. Wait for 5s and search it again.
Fig. 12 IP network setting
When accessing the M100 gateway through the Web, the IP address of the M100 gateway and the PC must be in the same network
segment. After changing the IP address of the M100 gateway, you can access the Web page of the M100 gateway through browser
and perform related configuration operations on it. The user name and initial password are both "admin".After entering the user name
and password, click "OK" and the server will authenticate. After success, you will enter the main page of the Web server, as shown in
Fig.13.
Fig. 13 The main interface of the Web server
The IP address of the PC must be modified to ensure that it is in the same local area network as the IP of the M100 gateway if you
want to connect M100 to PC directly via a net cable. The default IP address of M100 IO gateway is: 192.168.0.7. Set the PC's IP address
as: 192.168.0.X (X is any valid value from 2 to 253 except 7). The specific Windows system operation page is shown in Fig.14. you can
access the Web page of the USR-M100 gateway through browser as mentioned above.
To Next Page
Loading...