Usystems EDGE-3 - Gland Plates

Page 19
Installaon
Gland plates
The EDGE-3 has 6 gland plates which are removable. It is advised not to remove the gland plates during operaon as this will cause
issues with air recirculaon and potenal hot spots.
To remove the gland plate unscrew using a Philips head screw driver while holding onto the nut to avoid dropping if removing from
the top frame. Gland plates are put in ghtly to create a seal so it can be s removing and place back in.
To ensure opmum running eciency it is important that seal integrity is maintained by ulising either cable entry system (page
18) or other forms of cable grommets.
Gland plates