Usystems EDGE-3 - Plinth Kit Assembly

Page 21
Installaon
Plinth Assembly Instrucons
1. Remove the M10 allen key bolt and the M6 pozi nut and bolt from each corner of the base (note head of the M6 Bolt is locat-
ed inside the cabinet).
 Place the corresponding plinth corners (le hand and right hand) on each corner with the M6 bolt and nut and the M10 nut
as per removal (make sure the levelling foot is aached to the plinth corner before ng it onto the UCousc base).
 Once each plinth corner is ed proceed to t the external plinth panels using the M6 x 25 bolt onto a tapped hole on the
plinth corner.
 Unwind the levelling feet ll the castors are oang.