Usystems EDGE-3 - Moving the EDGE-3

EDGE-3 Soundproof MDC O&M
Page 8
Installaon
Unpacking instrucons
• The cabinet will be bubble and shrink wrapped as well as having protecve cardboard corners.
• When unpacking the cabinet do not run a blade all the way through the packaging as it may scratch the cabinet paint.
• Remove the cardboard corners by cung the tape.
• Pull o the shrink wrap.
• Un-ravel the bubble wrap.
The cabinet will be unlocked and the keys located inside on the front mounng angles.
Moving the EDGE-3
Moving instrucons
• When moving the cabinet with equipment inside, place the heavy equipment at the lower part of the 19 inch area.
• Maximum load on castors is 500kg.
• Make sure the levelling feet are up and push the cabinet only from the front or rear when moving the cabinet on its castors.
Never push the cabinet from the sides to avoid potenal pping.
• When installed ensure the adjustable feet are down and the cabinet is secured.
CAUTION
HAZARD
This cabinet can be pped. Use extreme cauon when unpacking or moving.
At least 2 people are required to unpack and move the cabinet.
Pung the cabinet in place of situ before installaon of the equipment.
When moving the equipment aer installaon, isolate, disconnect and stow the power cable to prevent
damage.