Usystems EDGE-3 - Quick Starter Guide

Page 25
Quick starter guide
1. The EDGE Management System is delivered from USystems with default sengs, please refer the EDGE Management
System User Guide for these sengs. These sengs should be adequate for most installaons, however adjustments can
be made to suit the requirement.
2. The EDGE Management System (EMS) requires either 100-130V or 200-240V 50/60Hz dedicated input power source. (Refer
to rang plate & model idencaon for details).
3. Once power has been applied to the EDGE Management System, the system shall inialise. The Acve door fans shall run at
full speed unl the EMS has completed its boot up and started the control sequence.
4. The LCD screen will require boot up me and is communicang with the EDGE Management System via wi-, a delay of up
to 5 minutes on boot up before communicaon has been established.
5. In order to use the WebUI (Web User Interface), an Ethernet cable from the EDGE Management System to your network is
needed. Plug the Ethernet cable into the EDGE Management System RJ45 port and then to a live network port onto your
own network. The network port on the EDGE Management System will light up to show it is live.
6. The default IP address to log on to the EDGE Management System is 192.168.0.10, please contact your network
administrator if unable to load the log in screen.
7. The default login is ‘admin’ and the password is ‘Admin12$’
8. Accept the EULA to proceed onto the WebUI
9. The following pages detail modifying default sengs on the EDGE Management System User Guide - Page 19 -21